Installing your Easy View Tackle System is simple. There are two ways to mount the system in your boat. It comes with easy to follow instructions.
You can mount the system with the adhesive mounting pads or with direct screw mounts.
The tools needed for installation are: 12″ ruler, Marker, Isopropyl (rubbing) Alcohol, Hacksaw (if needed to cut clip strips shorter), and a 1/8″ drill bit (for screw mount).
These photos show what the system looks like installed on a flat, carpeted surface. (Click to enlarge.)
A: Mounting pads installed with the adhesive
B: Clip strips placed in the cradle of the mounting pads and strap with the tie strap
C: System install complete
This system is designed for efficiency and to eliminate down time on the water. Placing one bag per clip will allow you to clip the back flap of the bag (as shown in photo 1).
This will make all of your baits easy accessible and highly visible. (as shown in photo 3) To retrieve a bait just pull on the front flap of the bag then reach in and grab a bait. (as shown in photo 2) It is not necessary to seal the bag back; you can seal the bag after your fishing day is over. (NOTE) When clipping the back flap of the bag you can line up the hanging hole of the bag with the clip jaw and pull it through the clip jaw and over the zipper of the bag. (as shown in photo 1) This will secure the bag and it will have to tear the bag for it to fall off. If you have a bag tear off you can clip the flap past the zip-lock of the bag to secure it (won’t tear off then).
Hang your spinner baits on one per clip (as shown in photo 3) so you have quick access, or two per clip for storage. By clipping your spinner bait as shown in the picture below you will display a good profile of your baits. (as shown in photo 1) This will make it easy to see the skirt color, size of the hook, size and color of the head, and type of blades on the bait. The following picture will show you how the spinner baits clip into the cradle of the clip jaw. Just press the clip button to release the bait of your choice and it’s ready for use. (as shown in photo 2)
Clipping the weed guard of the jig in the jaw of the clip allows you to profile all of your jigs. (as shown in photo 2) This is only one of many ways you can hang your jigs. When you select a jig you want to fish with just press the clip button, then tie it on! (as shown in photo 1)
You can purchase some small 3×3 bags at your local hobby store. Pre-tie your Carolina rigs, drop shot rigs, and grass rigs. (as shown in photo 1) This will cut down on lost time tying these rigs out there on the water during fishing time. Works great hanging the manufacturer’s hooks bags too. (as shown in photo 3) Then, simply open the bag, and get the hook, no need to detach the bag from the Easy View System. (as shown in photo 2)